[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
13 -FUEL > 13A-DIRECT INJECTION AND MULTIPOINT FUEL INJECTION (DI AND MPI) > TROUBLESHOOTING > DIAGNOSIS CODE PROCEDURES > CODE NO. P060D TRUSTFUL CHECK ACCELERATOR PEDAL POSITION SENSOR
Code No. P060D: Trustful Check Accelerator Pedal Position Sensor
 
 
 
 
FUNCTION
  • Compare the output value of the accelerator pedal position sensor (main) with that of the accelerator pedal position sensor (sub).
 
 
TROUBLE JUDGEMENT
Check Conditions
  • Ignition switch is "ON" position.
  • Battery positive voltage is more than 6.3 V.
Judgement Criteria
  • The difference between the output value of the accelerator pedal position sensor (main) and twice that of the accelerator pedal position sensor (sub) is 0.4 V or more.
 
 
FAIL-SAFE AND BACKUP FUNCTION
  • Throttle opening degree position is in default position.
 
 
PROBABLE CAUSES
  • Failed accelerator pedal position sensor
  • Harness damage in accelerator pedal position sensor circuit or loose connector contact
  • Failed engine-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE diagnosis code
Is any other diagnosis code than P060D set?
Inspection chart for diagnosis code (Refer to ).
Go to Step 2.
 
STEP 2. M.U.T.-IIISE data list
  • Data list reference table (Refer to ).
    1. Item 11: Accelerator pedal position sensor (main)
    2. Item 12: Accelerator pedal position sensor (sub)
Are the check results normal?
Go to Step 3.
Perform the diagnosis code classified check procedure for the sensor that has shown an abnormal data value. Inspection chart for diagnosis code (Refer to ).
 
STEP 3. M.U.T.-IIISE diagnosis code
  • Reconfirmation of diagnosis code.
Is the diagnosis code set?
Replace the engine-ECU.
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).