[ Model - ECLIPSE CROSS / Year - 2018 ]
Workshop Manual
Technical Information Manual
Body Repair Manual
Pre-delivery Inspection and Periodic Maintenance
PRINT
PRINT (GROUP)
2018 / ECLIPSE CROSS / EC - Workshop Manual
15 -INTAKE AND EXHAUST > AIR CLEANER > AIR CLEANER REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
caution
When removing or installing the air flow sensor, be careful not to apply impact to the sensor.
Do not reuse the air flow sensor that has been dropped.
Removal steps
1.
Air cleaner intake duct
2.
Breather hose<M/T>
3.
Air cleaner air intake hose<M/T>
4.
Breather hose<CVT>
5.
Air cleaner air intake hose<CVT>
>>A<<
6.
Air flow sensor
7.
O-ring
8.
Air cleaner cover
9.
Air cleaner element
10.
Air cleaner body
•
Engine-ECU (Refer to GROUP 13A - Engine-ECU
)
11.
Air cleaner bracket
INSTALLATION SERVICE POINT
>>A<< AIR CLEANER AIR FLOW SENSOR INSTALLATION
1.
Install the air flow sensor to the air cleaner cover with care not to damage the O-ring.
2.
caution
Do not over-tighten. If the mounting screw is over-tightened, the air cleaner cover can be damaged.
Tighten the mounting screws to the specified torque.
Tightening torque: 1.5 ± 0.3 N·m
