[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
17 -ENGINE AND EMISSION CONTROL > ADAPTIVE CRUISE CONTROL SYSTEM (ACC) > DIAGNOSIS CODE PROCEDURES > CODE NO. C2271: SAS SIGNAL FAIL
Code No. C2271: Steering Wheel Sensor Signal (Invalid)
 
 
caution
  • When the column switch assembly (Integrated with steering wheel sensor) is replaced, calibrate the steering wheel sensor (Refer to GROUP 35C - On-vehicle Service).
  • When the ACC/FCM-ECU is replaced, calibrate the radar (refer to ).
 
 
OPERATION
The ACC/FCM-ECU receives steering wheel angle signal from the steering wheel sensor.
 
 
DIAGNOSIS CODE SET CONDITION
Check Conditions
  • More than 2 seconds have passed since the ignition switch was turned to "ON" position.
  • ACC/FCM-ECU power voltage is more than 9 V and is less than 18 V.
Judgement Criterion
  • An invalid steering wheel angle signal received from the steering wheel sensor.
noteA diagnosis code is not set as a historic fault.
 
 
PROBABLE CAUSES
  • Malfunction of the column switch assembly (Integrated with steering wheel sensor)
  • Malfunction of the ACC/FCM-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check column switch assembly for correct mounting condition.
Is the check result normal?
Go to Step 2.
Repair.
 
STEP 2. M.U.T.-IIISE data list.
Check the following data list.
  • Item No.11: Steering wheel angle
OK:
  • Steering wheel neutral position (driving straight ahead): -5 to 5 degree
  • A turn of the steering wheel: Approximately equal to the amount the wheel will turn.
Is the check result normal?
Go to Step 3.
Replace the column switch assembly (Integrated with steering wheel sensor) (Refer to GROUP 35C - Steering Wheel Sensor ).
 
STEP 3. Check whether the diagnosis code is set again.
Is diagnosis code No. C2271 set?
Replace the ACC/FCM-ECU (Refer to ).
It can be assumed that this malfunction is intermittent (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunction ).