2018 / ECLIPSE CROSS / EC - Workshop Manual
23 -AUTOMATIC TRANSMISSION > 23A-CVT > TROUBLESHOOTING<CVT><CVT> > DIAGNOSIS CODE PROCEDURES > CODE NO. U1417 WRONG CODING DATA RECEIVED
Code No. U1417: Wrong coding data received
| caution | - If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
- Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
|
DIAGNOSTIC FUNCTION
CVT-ECU checks that the coding information is normal.
JUDGEMENT CRITERIA
The ETACS-ECU coding information about whether the AWC-ECU is mounted or not is incorrect.
PROBABLE CAUSES
- Malfunction of CAN bus line
- ETACS-ECU coding information is abnormal
- ETACS-ECU failure or improper assembly
- Malfunction of CVT-ECU
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics
STEP 2. M.U.T.-IIISE diagnosis code
Check if the ETACS-related diagnosis code is set.Is the ETACS-related diagnosis code set?
Carry out the appropriate troubleshooting.
Go to Step 3.
STEP 3. ETACS-ECU coding data check
Using M.U.T.-IIISE, check if any abnormality is present in the coding data below which is stored in the ETACS-ECU.Final drive
- OK: Front Drive <2WD>
- OK: 4WD FF Base <4WD>
Is the check result normal?
Go to Step 4. Replace the ETACS-ECU.
STEP 4. Symptom recheck after erasing diagnosis code
).