[ Model - ECLIPSE CROSS / Year - 2018 ]
Workshop Manual
Technical Information Manual
Body Repair Manual
Pre-delivery Inspection and Periodic Maintenance
PRINT
PRINT (GROUP)
SOLENOID VALVE CHECK
2018 / ECLIPSE CROSS / EC - Workshop Manual
23 -AUTOMATIC TRANSMISSION > 23A-CVT > ON-VEHICLE SERVICE > CVT CONTROL COMPONENT CHECK > CVT CONTROL SOLENOID VALVE ASSEMBLY CHECK
1.
While pressing A in the figure, turn B anti-clockwise to unlock the CVT assembly connector, and disconnect the connector.
2.
Measure the resistance between the terminals of the applicable solenoid valves and the earth.
Standard value:
Terminal No.
Applicable solenoid valve
Resistance value Ω
1
Line pressure solenoid valve
5.5 - 7.0 (fluid temperature: 20°C)
6.0 - 8.0 (fluid temperature: 50°C)
6.5 - 8.5 (fluid temperature: 80°C)
2
Primary pressure solenoid valve
3
Secondary pressure solenoid valve
4
Select solenoid valve
5
Lock-up solenoid valve
3.
When the resistance is within the standard value, check the power supply circuits.
4.
When the resistance is outside the standard value, check the valve body harness (Refer to
).
(1)
If the valve body harness is defective, replace it (Refer to
).
(2)
caution
Each solenoid valve cannot be removed or replaced as a single unit.
If the valve body wiring harness is normal, replace the valve body assembly (Refer to
).
).).).