[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
23 -AUTOMATIC TRANSMISSION > 23A-CVT > TROUBLESHOOTING<S-AWC><S-AWC> > DIAGNOSIS CODE PROCEDURES > CODE NO. U1427 WHEEL SPEED SENSOR DATA MALFUNCTION
Code No.U1427: Wheel Speed Sensor Data Malfunction
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
AWC-ECU communicates with the ASC-ECU via the CAN bus lines.
 
 
DIAGNOSIS CODE SET CONDITIONS
The code is set when abnormality is detected in the wheel speed sensor signal received from the ASC-ECU.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • Malfunction of the wheel speed sensor
  • Malfunction of ASC-ECU
  • Malfunction of AWC-ECU

 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use M.U.T.-IIISE to perform the CAN bus diagnosis.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code.
Check the ASC diagnosis code (Refer to GROUP 35C - Troubleshooting ).
Is the diagnosis code set?
Perform the relevant troubleshooting.
Go to Step 3.
 
STEP 3. M.U.T.-IIISE data list.
Check the data list of the relevant wheel speed sensor (Refer to ).
  • Item No.35: Wheel speed (FL)
  • Item No.36: Wheel speed (FR)
  • Item No.37: Wheel speed (RL)
  • Item No.38: Wheel speed (RR)
Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
Go to Step 4.
 
STEP 4. Check whether the diagnosis code is set again.
Is diagnosis code No.U1427 set?
Replace the AWC-ECU (Refer to ).
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).