[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
35 -SERVICE BRAKES > 35A-BASIC BRAKE > BRAKE PEDAL > BRAKE PEDAL REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
cautionDo not apply lubricant (grease or silicon system sprayer etc.) to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have lubricant (grease or silicon system sprayer etc.) on them.
Pre-removal Operation
  • Instrument Panel Under Cover Removal (Refer to GROUP 52A - Instrument Lower Panel ).
Post-installation Operation
  • Instrument Panel Under Cover Installation (Refer to GROUP 52A - Instrument Lower Panel ).
  • Brake Pedal Adjustment (Refer to ).
 
Brake pedal assembly removal steps
>>A<<1.Stop lamp switch connector connection
>>A<<2.Stop lamp switch
3.Pedal clip
4.Pedal stopper
5.Snap pin
6.Pin assembly
7.Pedal pad
<<A>>8.Brake pedal assembly
 
 
REMOVAL SERVICE POINT
 
 
<<A>> BRAKE PEDAL ASSEMBLY REMOVAL
From the engine compartment side, remove the brake pedal assembly while pulling the brake booster.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< STOP LAMP SWITCH / STOP LAMP SWITCH CONNECTOR INSTALLATION
 
Install the stop lamp switch in the following procedure:
1. Insert the stop lamp switch into the key hole on the plate.
2. While holding the brake pedal upwards, push in the stop lamp switch to the stop position.
3. Lock the stop lamp switch body by twisting it clockwise.
4. Check that the clearance between the stop lamp switch and the pedal stopper is within the standard value.
Standard value (A): 0.5 - 1.5 mm
5.
cautionMake sure that the stop lamp is not illuminated when the brake pedal is not depressed.
Connect the stop lamp switch connector.