2018 / ECLIPSE CROSS / EC - Workshop Manual
35 -SERVICE BRAKES > 35C-ACTIVE STABILITY CONTROL SYSTEM (ASC) > TROUBLESHOOTING<ASC-ECU><ASC-ECU> > DIAGNOSIS CODE PROCEDURES > CODE NO. C2205: INTERNAL MALFUNCTION OF STEERING WHEEL SENSOR
Code No. C2205: SAS Internal Error
| caution | - If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table
 ). - Whenever ECU is replaced, ensure that the CAN bus lines are normal.
|
OPERATION
Steering wheel sensor sends its status signal to ASC-ECU.
DIAGNOSIS CODE SET CONDITIONS
This diagnosis code is set when ASC-ECU detects that the steering wheel sensor has malfunction.
PROBABLE CAUSES
- Steering wheel sensor malfunction
- ASC-ECU malfunction
- External noise interference
DIAGNOSIS PROCEDURE
1. Check M.U.T.-IIISE CAN bus diagnostics
2. Check whether the diagnosis code is set again. <Steering wheel sensor>
3. Check whether the diagnosis code is set again.
