Mitsubishi Motors Service Manual

2018 / ECLIPSE CROSS / EC - Workshop Manual

42 -BODY > 42A-BODY > DOOR > DOOR HANDLE AND LATCH > DOOR HANDLE AND LATCH REMOVAL AND INSTALLATION

REMOVAL AND INSTALLATION

Pre-removal operation

Door trim assembly removal (Refer to GROUP 52A, Door Trim ).
Door working hole cover front removal (Refer to ).

Post-installation operation

Door inside handle play check (Refer to ).
Door outside handle play check (Refer to ).
Door working hole cover front installation (Refer to ).
Door trim assembly installation (Refer to GROUP 52A, Door Trim ).

			Door inside handle removal
		1.	Door inside handle
			Door outside handle removal steps
		2.	Front door lock cover (Driver’s side) <Vehicles with dead lock system>
		3.	Damper (Driver’s side) <Vehicles with dead lock system>
		4.	Door lock key cylinder (Driver's side)
		5.	Door outside handle cover
		6.	Door outside handle
		7.	Door outside handle gasket
		8.	Door outside handle base
		9.	Clip
			Door latch assembly removal steps
		1.	Door inside handle
		10.	Door speaker bracket <Vehicles with audio amplifier>
		11.	Screw
<<A>>		12.	Door lock cover
<<A>>		13.	Door latch assembly
	>>B<<	14.	Door inside lock cable
	>>B<<	15.	Door inside handle cable
		16.	Door outside handle rod
		17.	Clip
			Door check removal steps
		•	Front door speaker (Refer to GROUP 54A, Speaker ).
	>>A<<	18.	Door check

			Door inside handle removal
		1.	Door inside handle
			Door outside handle removal steps
		2.	Door outside handle cover
		3.	Door outside handle
		4.	Door outside handle gasket
		5.	Clip
		6.	Door outside handle base
			Door latch assembly removal steps
		1.	Door inside handle
		7.	Door speaker bracket <Vehicles with audio amplifier>
		8.	Screw
<<A>>		9.	Door lock cover
<<A>>		10.	Door latch assembly
	>>B<<	11.	Door inside lock cable
	>>B<<	12.	Door inside handle cable
		13.	Door outside handle rod
			Door check removal steps
		•	Rear door speaker (Refer to GROUP 54A, Speaker )
		14.	Clip
	>>A<<	15.	Door check

REMOVAL SERVICE POINT

<<A>> DOOR LOCK COVER/ DOOR LATCH ASSEMBLY REMOVAL

Remove the door lock cover in the following procedures:

1. Release the upper and lower claws of the door lock cover by using a flat-tipped screwdriver.

2. Pull the cover out a little.

3. With the cover pulled out state, slide it toward cabled side and remove it from the door latch assembly.

INSTALLATION SERVICE POINTS

>>A<< DOOR CHECK INSTALLATION

Install the door check with the following identification mark facing upward.

Application		Identification mark
Front door	Left door	FL
Front door	Right door	FR
Rear door	Left door	RL
Rear door	Right door	RR

>>B<< DOOR INSIDE LOCK CABLE/ DOOR INSIDE HANDLE CABLE INSTALLATION

Connect the door inside lock cable and door inside handle cable to the door inside handle according to the identification colour marked on the cables as shown in the illustration.