[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
51 -EXTERIOR > REAR WIPER AND WASHER > REAR WIPER AND WASHER > REAR WIPER AND WASHER REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
 
Rear wiper blade removal steps
>>A<<1.Rear wiper blade
Rear wiper blade assembly removal steps
2.Rear wiper blade assembly
Rear wiper motor removal steps
3.Cover
>>B<<4.Rear wiper arm assembly
•Tailgate trim (Refer to GROUP 52A, Tailgate Trim )
5.Grommet
6.Rear wiper motor assembly
Rear washer nozzle removal steps
•Tailgate spoiler (Refer to GROUP 51, Tailgate Spoiler )
7.Rear washer nozzle assembly
Rear washer hose removal steps
•Front/rear scuff plate, cowl side trim, quarter trim (Refer to GROUP 52A, Interior Trim )
8.Rear washer hose
noteFor removal and installation of the column switch assembly, refer to GROUP 54A, Column Switch .
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< REAR WIPER BLADE INSTALLATION
 
cautionUse a curved backing like that shown for the backing of a wiper blade to ensure sustained wiper wiping performance.
 

 
 
>>B<< REAR WIPER ARM AND BLADE ASSEMBLY INSTALLATION
 
Assemble the wiper blade so that their edge stops at the specified position.
Standard value:
(A): Φ 2 marking ± 5 mm