[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
52 -INTERIOR AND SUPPLEMENTAL RESTRAINT SYSTEM(SRS) > 52A-INTERIOR > HEADLINING > HEADLINING REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
cautionBefore removing and installing the headlining, refer to GROUP 52B - SRS Service Precautions and Curtain Air Bag Module .
Pre-removal and Post-installation Operation
  • Front Pillar Trim, Centre Pillar Trim Upper, Quarter Trim Upper Removal and Installation (Refer to ).
  • Inside Rear View Mirror Removal and Installation (Refer to ).
 
<Standard roof>
Removal steps
1.Assist grip cover <driver’s side>
2.Assist grip
3.Sun visor assembly
4.Front room lamp assembly
<<A>>5.Sun visor holder
<<B>>6.Headlining assembly
7.Room lamp clip
8.Rear room lamp assembly
9.Roof sub wiring harness
10.Headlining
>>A<<11.Headlining pad
12.Map lamp bracket
>>A<<13.Headlining pad
•Curtain air bag module (Refer to GROUP 52B - Curtain Air Bag Module ).
14.Assist grip bracket
 
<Power panoramic sunroof>
Removal steps
1.Assist grip cover <Driver’s side>
2.Assist grip
3.Sun visor assembly
4.Front room lamp assembly
<<A>>5.Sun visor holder
<<B>>6.Headlining assembly
7.Rear room lamp assembly
8.Rear shade switch assembly
9.Rear shade switch
10.Rear shade switch cover
11.Roof sub wiring harness
12.Headlining
13.Map lamp bracket
•Curtain air bag module (Refer to GROUP 52B - Curtain Air Bag Module ).
14.Assist grip bracket
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> SUNVISOR HOLDER REMOVAL
 
Insert the special tools ornament remover (MB990784) into the sunvisor holder from its left and right sides to disengage the claws on the sunvisor holder sides.
 

 
 
<<B>> HEADLINING ASSEMBLY REMOVAL
 
1. To remove the clip, insert a vinyl cord into a clearance between the clip and the headlining, and pass it around the clip. Then, pull out the clip downwards while pulling the vinyl cord.
 
2. For the power panoramic sunroof-equipped car, use the special tool ornament remover (MB990784) to separate each dual lock fastener fixing the headlining and body.
3. Carry out the headlining assembly from the tailgate opening while deflecting the headlining.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< HEADLINING PAD INSTALLATION
 
Install the headlining pad so that the notched section will fit the illustrated position.