2018 / ECLIPSE CROSS / EC - Workshop Manual
52 -INTERIOR AND SUPPLEMENTAL RESTRAINT SYSTEM(SRS) > 52A-INTERIOR > INSTRUMENT CENTRE PANEL > INSTRUMENT CENTRE PANEL REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
 
 
 
Removal steps
<<A>>1.Instrument panel air outlet panel assembly
2.Instrument panel air outlet centre
3.Hazard warning lamp switch
4.Instrument panel air outlet panel
Multivision display assembly (Refer to GROUP 54A - Multivision Display ) <Smartphone link display audio>.
Radio and CD player assembly (Refer to GROUP 54A - Radio and CD Player ) <1CD audio/Display audio>.
Multivision display assembly (Refer to GROUP 54A - MMCS ) <MMCS>.
5.Instrument panel air outlet plug <some models>
<<B>>6.A/C controller panel assembly
A/C controller assembly (Refer to GROUP 55 - A/C Control Unit ).
7.A/C controller panel
8.Instrument panel mat
Floor console centre (Refer to ).
9.Instrument panel console box centre assembly
10.Instrument panel lamp assembly
11.Spot lamp
12.Switch or switch plug
USB adapter or USB adapter plug (Refer to GROUP 54A - USB cable ).
Accessory socket assembly (Refer to GROUP 54A - Accessory Socket ).
13.Instrument panel console box centre
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> INSTRUMENT PANEL AIR OUTLET PANEL ASSEMBLY REMOVAL
 
Insert the special tool ornament remover (MB990784) into each notch on the lower side of the instrument panel air outlet panel to remove it.
 

 
 
<<B>> A/C CONTROLLER PANEL ASSEMBLY REMOVAL
 
Insert the special tool ornament remover (MB990784) into each notch on the lower side of the A/C controller panel to remove it.