[ Model - ECLIPSE CROSS / Year - 2018 ]
Workshop Manual
Technical Information Manual
Body Repair Manual
Pre-delivery Inspection and Periodic Maintenance
PRINT
PRINT (GROUP)
2018 / ECLIPSE CROSS / EC - Workshop Manual
52 -INTERIOR AND SUPPLEMENTAL RESTRAINT SYSTEM(SRS) > 52A-INTERIOR > REAR SEAT ASSEMBLY > REAR SEAT ASSEMBLY > REAR SEAT ASSEMBLY REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
Removal steps
1.
Headrestraint
•
Rear scuff plate (Refer to
).
2.
Rear seat anchor cover front
3.
Rear seat anchor cover rear
4.
Wiring harness connector connection [rear seat belt switch, heated seat (rear)]
>>A<<
5.
Rear seat assembly
INSTALLATION SERVICE POINT
>>A<< REAR SEAT ASSEMBLY INSTALLATION
1.
Insert the seat pins to holes of the body securely.
2.
Confirm that both the seat slides are locked, and then temporarily tighten the front side bolts so that no load is applied to the seat cushion.
3.
Tighten the front side bolts to the specified torque.
Tightening torque: 43 ± 8 N·m
4.
Move the seat forward.
5.
Confirm that both the seat slides are locked, and then temporarily tighten the rear side bolts so that no load is applied to the seat cushion.
6.
Tighten the rear side bolts to the specified torque.
Tightening torque:
M10: 43 ± 8 N·m
M12: 75 ± 19 N·m
).