[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
52 -INTERIOR AND SUPPLEMENTAL RESTRAINT SYSTEM(SRS) > 52B-SUPPLEMENTAL RESTRAINT SYSTEM (SRS) > SIDE IMPACT SENSOR > SIDE IMPACT SENSOR REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
caution
  • Disconnect the negative (-) battery terminal and wait for 60 seconds or more before starting work. Insulate the disconnected (-) terminal by wrapping the tape (Refer to the item 5 of Service Precautions ).
  • Never attempt to disassemble or repair the side impact sensor. If damaged, replace it with new one(s).
  • Handle the side impact sensor with sufficient caution, and do not drop or subject the sensor to impact or vibration. If there is a dent, crack, or deformation, replace with a new sensor.
  • After the side/curtain air bag deployment, replace with a new sensor.
 
 
Pre-removal operation
Turn the ignition switch to the "LOCK" (OFF) position.
 
Side impact sensor removal steps
•Disconnect the negative (-) battery terminal.
•Seat belt with pre-tensioner (Refer to ).
<<A>>1.Side impact sensor
Side impact sensor installation steps
>>A<<•Pre-installation inspection
•Disconnect the negative (-) battery terminal.
>>B<<1.Side impact sensor
•Seat belt with pre-tensioner (Refer to ).
•Connect the negative (-) battery terminal.
>>C<<•Post-installation inspection
 
 
REMOVAL SERVICE POINT
 
 
<<A>> SIDE IMPACT SENSOR CONNECTOR REMOVAL
 
Push the connector lock of the side impact sensor connector at the part of the arrow to release the lock, and disconnect the connector.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< PRE-INSTALLATION INSPECTION
Even when installing a new side impact sensor, perform an inspection before the installation (Refer to the item on inspection).
 
 
 
>>B<< SIDE IMPACT SENSOR INSTALLATION
cautionIf the side impact sensor is not securely and correctly installed, the correct operation of side/curtain air bag is prevented.
Connect the connector securely.
 
 
 
>>C<< POST-INSTALLATION INSPECTION
1. Turn the ignition switch to the "ON" position.
 
2. Check that the SRS warning lamp is illuminated for 6 to 8 seconds, and extinguished afterward.
3. If the lamp does not extinguish, perform the troubleshooting.