[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
52 -INTERIOR AND SUPPLEMENTAL RESTRAINT SYSTEM(SRS) > 52B-SUPPLEMENTAL RESTRAINT SYSTEM (SRS) > TROUBLESHOOTING > DIAGNOSIS CODE PROCEDURES > DTC B1426 G-SENSOR OF SIDE IMPACT SENSOR (RH)FAILURE
Code No.B1426 Malfunction of G-sensor inside right side impact sensor
Code No.B1436 Malfunction of G-sensor inside left side impact sensor
 
 
cautionIf the diagnosis code B1426 or B1436 is set to SRS-ECU, be sure to diagnose the CAN bus line.
 
 
TROUBLE JUDGEMENT
  • Analogue G-sensor for side impact does not operate.
  • Characteristics of analogue G-sensor for side impact are abnormal.
  • Output of analogue G-sensor for side impact is abnormal.
 
 
PROBABLE CAUSES
  • Malfunction of right side impact sensor (with code No. B1426)
  • Malfunction of left side impact sensor (with code No. B1436)
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. Side impact sensor check.
(1) Check that the negative battery terminal is disconnected. If the negative battery terminal is connected, disconnect it.
(2) A side impact sensor is checked in the following way.
  • Replace the right side impact sensor {In case of code B1426 (Regardless of "Active" or "Stored" faults)} with the new part.
  • Replace the left side impact sensor {In case of code B1436 (Regardless of "Active" or "Stored" faults)} with the new part.
(3) Connect the negative battery terminal.
(4) After erasing the diagnosis code memory, check the diagnosis code again.
(5) Disconnect the negative battery terminal.
Is the diagnosis code No. B1426 or B1436 set?
Replace the SRS-ECU (Refer to ).
An intermittent malfunction is suspected (Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).