Mitsubishi Motors Service Manual

2018 / ECLIPSE CROSS / EC - Workshop Manual

52 -INTERIOR AND SUPPLEMENTAL RESTRAINT SYSTEM(SRS) > 52B-SUPPLEMENTAL RESTRAINT SYSTEM (SRS) > PASSENGER'S AIR BAG CUT OFF SWITCH > PASSENGER AIR BAG CUT OFF SWITCH REMOVAL AND INSTALLATION

REMOVAL AND INSTALLATION

warning

Never attempt to disassemble or repair the passenger’s air bag cut off switch. If faulty, replace it.

Do not drop or subject the passenger’s air bag cut off switch to impact or vibration. Replace the passenger’s air bag cut off switch, if a dent, cracking, deformation, or rust is present.

Pre-removal Operation

Turn the ignition key to the "LOCK" (OFF) position.

		Removal steps
	•	Disconnect the negative (-) battery terminal.
	•	Instrument panel side cover (Refer to GROUP 52A - Instrument panel assembly ).
	•	Glovebox case assembly (Refer to GROUP 52A - Glove Box ).
	1.	Passenger’s air bag cut off switch holder
	2.	Passenger’s air bag cut off switch
		Installation steps
>>A<<	•	Pre-installation inspection
	•	Disconnect the negative (-) battery terminal.
>>B<<	2.	Passenger’s air bag cut off switch
	1.	Passenger’s air bag cut off switch holder
	•	Glovebox case assembly (Refer to GROUP 52A - Glove Box ).
	•	Instrument panel side cover (Refer to GROUP 52A - Instrument panel assembly ).
	•	Connect the negative (-) battery terminal.
>>C<<	•	Post-installation inspection

INSTALLATION SERVICE POINTS

>>A<< PRE-INSTALLATION INSPECTION

Check the passenger’s air bag cut off switch for dents, breakage and bending and measure the resistance between the terminals, even when installing a new passenger’s air bag cut off switch.

>>B<< PASSENGER’S AIR BAG CUT OFF SWITCH INSTALLATION

warning

If the passenger’s air bag cut off switch is not installed securely and correctly, the passenger’s (front) air bag may not operate normally.

Securely connect the connector.

>>C<< POST-INSTALLATION INSPECTION

1. Turn the ignition switch to the "ON" position.

2. Check that the SRS warning lamp is illuminated for 6 to 8 seconds, and extinguished afterward.

3. If the lamp does not extinguish, perform the troubleshooting.

4. Turn the ignition switch to the "ON" position.

Check that the passenger’s air bag OFF indicator lamp is illuminated for 6 to 8 seconds, and extinguished afterward.

6. If the lamp does not extinguish, perform the troubleshooting.