[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
52 -INTERIOR AND SUPPLEMENTAL RESTRAINT SYSTEM(SRS) > 52A-INTERIOR > INSTRUMENT PANEL ASSEMBLY > INSTRUMENT PANEL ASSEMBLY REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
The following bolts and screws are used for installing the instrument panel. Bolts and screws are indicated as marks shown in the illustration in the sections of "Removal and Installation" and "Disassembly and Assembly."
NameSymbolSize (D X L) mmColourShape
Tapping screwa5 X 12-
 
b5 X 16-
c5 X 12-
 
d5 X 16-
Washer assembly bolte6 X 16-
 
D: Thread diameter, L: Effective thread length
 
 
caution
  • Before removal and installation the SRS components, refer to GROUP 52B - SRS Service Precautions , Passenger’s Air Bag Cut Off Switch , Knee Air Bag Module and Passenger’s (Front) Air Bag Module .
  • Do not subject the SRS-ECU to any shocks when removing or installing the instrument panel.
 
 
Instrument panel side cover removal steps
1.Instrument panel side cover
•Passenger’s air bag cut off switch (Refer to GROUP 52B - Passenger’s Air Bag Cut Off Switch ).
Front speaker garnish removal
2.Front speaker garnish
Instrument panel side air outlet removal
3.Instrument panel side air outlet
Combination meter bezel removal steps
•Combination meter bezel (Refer to GROUP 54A - Combination Meter ).
4.Engine switch or switch plug
Steering column cover removal steps
5.Instrument panel key cylinder panel <Vehicles with OSS>
6.Steering column cover lower
7.Steering column cover upper
 
 
 
Removal steps
•Front pillar trim (Refer to ).
•Glovebox case assembly (Refer to ).
•Instrument panel lower assembly (Refer to ).
•Knee air bag module (Refer to GROUP 52B - Knee Air Bag Module ).
•Instrument panel console box centre assembly (Refer to ).
•Combination meter assembly (Refer to GROUP 54A - Combination Meter ).
•Head up display (Refer to GROUP 54A - Head Up Display ).
•Tweeter (Refer to GROUP 54A - Speaker ).
•Passenger’s (front) air bag module connection (Refer to GROUP 52B - Passenger’s (Front) Air Bag Module ).
•Wiring harness connection
1.Instrument panel assembly
2.Instrument panel control unit bracket <RHD>
3.Instrument panel knee protector bracket