[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > COMBINATION METER > DIAGNOSIS CODE PROCEDURES > CODE No.U0159 TIME-OUT DURING CAN COMMUNICATION WITH CAMERA-ECU<VEHICLES WITH MULTI AROUND MONITOR><VEHICLES WITH MULTI AROUND MONITOR>
Code No.U0159 CAMERA CAN timeout <Vehicles with multi around monitor>
 
 
caution
  • If diagnosis code No. U0159 is set, be sure to diagnose the CAN bus line.
  • Before replacing the ECU or combination meter, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
 
 
DIAGNOSTIC FUNCTION
If the signal from camera-ECU cannot be received, the combination meter sets diagnosis code No. U0159.
 
 
JUDGEMENT CRITERIA
With the ignition switch is at ON position, the diagnosis code No. U1190 is not set and the diagnosis code No. U1195 is not set, if the communication with camera-ECU cannot be established for 2500 ms or more, the combination meter determines that a problem has occurred.
 
 
PROBABLE CAUSES
  • Malfunction of CAN bus line
  • Malfunction of the camera-ECU
  • Malfunction of combination meter
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code
Check if diagnosis code is set in the camera-ECU.
Is the diagnosis code set?
Troubleshoot the multi around monitor (Refer to ).
Go to Step 3.
 
STEP 3. M.U.T.-IIISE other system diagnosis code
Check if a diagnosis code, which relates to CAN communication-linked systems below, is set.
  • ETACS-ECU
    • Code No. U0159: CAMERA CAN timeout
Is the diagnosis code set?
Go to Step 4.
Go to Step 5.
 
STEP 4. Check whether the diagnosis code is set again.
Recheck if the diagnosis code is set.
(1) Erase the diagnosis code.
(2) Turn the ignition switch to "ON" position.
(3) On completion, check that the diagnosis code is not set again.
Is the diagnosis code set?
Replace camera-ECU.
A poor connection, open circuit or other intermittent malfunction is present in the CAN bus lines between the camera-ECU and the combination meter (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 5. Check whether the diagnosis code is set again.
Recheck if the diagnosis code is set.
(1) Erase the diagnosis code.
(2) Turn the ignition switch to "ON" position.
(3) On completion, check that the diagnosis code is not set again.
Is the diagnosis code set?
Replace combination meter.
A poor connection, open circuit or other intermittent malfunction is present in the CAN bus lines between the camera-ECU and the combination meter (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).