[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > HEADLAMP AUTOMATIC LEVELLING SYSTEM<Vehicles with headlamp auto levelling system><Vehicles with headlamp auto levelling system> > DIAGNOSIS CODE CHART
DIAGNOSIS CODE CHART
caution
  • On troubleshooting, if the ignition switch is turned ON while disconnecting connector(s), diagnosis code(s) associated with other system may be set. On completion, confirm all systems for diagnosis code(s). If diagnosis code(s) are set, erase them all.
  • Before or after the troubleshooting, check the operation of the headlamp automatic levelling system. Refer to .
Diagnosis code No.Diagnostic itemReference page
B2215ETACS-ECUECU internal error (EEPROM)Refer to Diagnosis code chart .
B222CCoding not completed
B2510Height Sensor Not Initialised
B2513Levelling actuator output voltage
B2514Height sensor supply voltage
B2515Front height sensor signal
B2516Rear height sensor signal
U0100ETACS-ECUEngine CAN timeoutRefer to Diagnosis code chart .
U0121ABS/ASC CAN timeout
U0155Meter CAN timeout
U0331ECU internal error (ROM)