[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > ULTRASONIC MISACCELERATION MITIGATION SYSTEM/CORNER SENSOR SYSTEM > DIAGNOSIS CODE PROCEDURES > CODE No. C2237 ROL sensor received signal lost
Code No. C2237 RL corner sensor signal lost
 
 
 
 
OPERATION
The clearance warning control unit sets diagnosis code No.C2237 when it does not receive any signal from the rear corner clearance sensor (LH) for at least three seconds.
note
  • If some or all of diagnosis codes C2236 to C2239 are set together with this DTC, the power supply or earth wires for the sensor may be open-circuited.
  • Diagnosis code C2243 will be set instead of this DTC when the sensor power supply circuit is short to power supply or earth.
 
 
TROUBLE JUDGEMENT
The condition below is satisfied:
  • The rear corner clearance sensor (LH) has not sent any signal for at least three seconds.
 
 
PROBABLE CAUSES
  • Malfunction of rear corner clearance sensor (LH)
  • Malfunction of clearance warning control unit
  • Damaged harness wires and connectors
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check of short to earth, and open circuit in PIUS, SROL and GIUS line between rear corner clearance sensor (LH) connector and clearance warning control unit connector.
noteTo check electric continuity, always select a resistance range of a multimeter.
Is the check result normal?
Go to Step 2.
Repair the connector(s) or wiring harness.
 
STEP 2. Check the rear corner clearance sensor (LH).
Substitute a known good rear side sensor.
(1) Substitute a known good rear side sensor.
(2) Erase the diagnosis code.
(3) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(4) The diagnosis code representing the substituted sensor should be set, but diagnosis code C2237 should not be set.
Is the check result normal?
Replace the rear corner clearance sensor (LH) (Refer to ).
Go to Step 3.
 
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the clearance warning control unit.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if diagnosis code is set.
Is the diagnosis code set?
Replace the clearance warning control unit (Refer to ).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).