[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > ULTRASONIC MISACCELERATION MITIGATION SYSTEM/CORNER SENSOR SYSTEM > CLEARANCE WARNING CONTROL UNIT > CLEARANCE WARNING CONTROL UNIT REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
cautionWhen you replace the camera-ECU, you should teach the camera-ECU for the multi-around monitor by writing a learned value. On completion, you should check the camera image on the multi around monitor "Bird’s eye-view." If necessary, calibrate the camera (Refer to ). <Vehicles with multi around monitor>
Pre-removal and Post-installation Operation
  • Instrument Panel Side Cover (RH) Removal and Installation (Refer to GROUP 52A - Instrument Panel Assembly ).
  • Glovebox and Instrument Panel Under Cover Assembly Removal and Installation (Refer to GROUP 52A - Glove Box ). <LHD>
  • Instrument Panel Cover Lower Removal and Installation (Refer to GROUP 52A - Instrument Lower Panel ). <RHD>
  • Cowl Side Trim Removal and Installation (Refer to GROUP 52A - Trims, Interior Trim ).
 
Removal steps
1.Clearance warning control unit and camera-ECU sub wiring harness
2.DC/DC converter, camera-ECU, clearance warning control unit, bracket
3.DC/DC converter
4.Camera-ECU
5.Clearance warning control unit
6.Bracket