[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > MULTI AROUND MONITOR > SYMPTOM PROCEDURES > A camera is not switched when the camera switch is pressed.
Inspection Procedure 6: A camera image is displayed when the selector lever is moved to the R position, but it is not switched when the camera switch is pressed.
 
 
 
 
COMMENT ON TROUBLE SYMPTOM
A camera image is displayed when the selector lever is moved to the R position, but it is not switched when the camera switch is pressed. In this case, the camera input signal system may be defective.
 
 
PROBABLE CAUSES
  • Malfunction of camera-ECU
  • Malfunction of camera switch (steering wheel remote control switch)
  • Malfunction of CAN bus
  • Damaged harness wires and connectors
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE data list.
Using the camera-ECU service data.
  • Operate the camera switch.
 
Item No.M.U.T.-IIISE displayCheck conditionNormal condition
5Camera switchCamera switch: OFF OFF
Camera switch: ONON
Is the check result normal?
Go to Step 5.
Go to Step 3.
 
STEP 3. Check the operation of the audio remote control switch.
Check that the audio remote control switch operation normally.
Is the check result normal?
Go to Step 4.
Troubleshoot the audio remote control switch (Refer to ).
 
STEP 4. Check the camera switch (steering wheel remote control switch).
Check the camera switch (Refer to ).
Is the check result normal?
Replace the radio and CD player <vehicles with display audio> or multivision display <vehicles with smartphone link display audio or MMCS>.
Replace the steering wheel remote control switch.
 
STEP 5. Retest the system.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the camera-ECU (Refer to ).