[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > MULTI AROUND MONITOR > DIAGNOSIS CODE PROCEDURES > Code No.U0141 ETACS CAN timeout
Code No.U0141 ETACS CAN timeout
 
 
caution
  • If diagnosis code No.U0141 is set, be sure to diagnose the CAN bus line.
  • Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.
 
 
TROUBLE JUDGEMENT
If signal from the ETACS-ECU cannot be received for 2,500 ms or more, the camera-ECU sets diagnosis code No.U0141.
 
 
PROBABLE CAUSES
  • Malfunction of ETACS-ECU
  • Malfunction of camera-ECU
  • Malfunction of CAN bus
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code
Check if diagnosis code No.U0141 is set in the combination meter.
Is the diagnosis code set?
Go to Step 3.
Go to Step 4.
 
STEP 3. Diagnosis code recheck
Check again if the diagnosis code is set in the camera-ECU.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the diagnosis code is set.
Is the diagnosis code set?
Replace the ETACS-ECU.
A poor connection, open circuit, or other intermittent malfunction in the CAN bus line between the camera-ECU and the ETACS-ECU (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 4. Diagnosis code recheck
Check again if the diagnosis code is set in the camera-ECU.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the diagnosis code is set.
Is the diagnosis code set?
Replace the camera-ECU (Refer to ).
A poor connection, open circuit, or other intermittent malfunction in the CAN bus line between the camera-ECU and the ETACS-ECU (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).