[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > MULTI AROUND MONITOR > DIAGNOSIS CODE PROCEDURES > Code No.U0245 NAVI/DISP.AUDIO CAN timeout<vehicles with MMCS><vehicles with MMCS>
Code No.U0245 NAVI/DISP.AUDIO CAN timeout <vehicles with smartphone link display audio or MMCS>
 
 
caution
  • If diagnosis code No.U0245 is set, be sure to diagnose the CAN bus line.
  • Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.
 
 
TROUBLE JUDGEMENT
If signal from the multivision display <vehicles with smartphone link display audio> or CAN box unit (MMCS) <vehicles with MMCS> cannot be received for 2,500 ms or more, the camera-ECU sets diagnosis code No.U0245.
 
 
PROBABLE CAUSES
  • Malfunction of multivision display <vehicles with smartphone link display audio>
  • Malfunction of CAN box unit (MMCS) <vehicles with MMCS>
  • Malfunction of camera-ECU
  • Malfunction of CAN bus
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code.
Check if diagnosis code No.U0245 is set in the combination meter.
Is the diagnosis code set?
Go to Step 3.
Go to Step 4.
 
STEP 3. Diagnosis code recheck.
Check again if the diagnosis code is set in the camera-ECU.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the diagnosis code is set.
Is the diagnosis code set?
Replace the multivision display <vehicles with smartphone link display audio> or CAN box unit (MMCS) <vehicles with MMCS>.
A poor connection, open circuit, or other intermittent malfunction in the CAN bus line between the camera-ECU and the multivision display <vehicles with smartphone link display audio> or CAN box unit (MMCS) <vehicles with MMCS> (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 4. Diagnosis code recheck.
Check again if the diagnosis code is set in the camera-ECU.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the diagnosis code is set.
Is the diagnosis code set?
Replace the camera-ECU (Refer to ).
A poor connection, open circuit, or other intermittent malfunction in the CAN bus line between the camera-ECU and the multivision display <vehicles with smartphone link display audio> or CAN box unit (MMCS) <vehicles with MMCS> (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).