[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > IGNITION SWITCH<Vehicles without keyless operation system><Vehicles without keyless operation system> > IGNITION SWITCH > IGNITION SWITCH REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
Pre-removal and Post-installation Operation
Steering Column Cover Lower and Steering Column Cover Upper Removal and Installation (Refer to GROUP 52A - Instrument Panel Assembly ).
 
Removal Steps
1.Ignition switch
2.Steering lock solenoid
<<A>>3.Steering lock cylinder
•Windshield wiper & windshield washer switch (Refer to .)
4.Key reminder switch and key ring antenna assembly
noteOther than the single unit supplying of key reminder switch and key ring antenna assembly as well as of ignition switch, they are also supplied as the mechanical steering lock assembly (mechanical steering lock, steering lock bracket, steering lock bolt, key reminder switch and key ring antenna assembly, and ignition switch are supplied as a set). For how to remove the mechanical steering lock, steering lock bracket, and steering lock bolt, refer to GROUP 37 - Steering Shaft Disassembly and Reassembly .
 
 
REMOVAL SERVICE POINT
 
 
<<A>> STEERING LOCK CYLINDER REMOVAL
1. Insert the key into the steering lock cylinder, and turn the ignition key to the "ACC" position.
 
 
2. Using a flat-tipped precision screwdriver or similar tool, press the lock button located at the part "A" shown in the figure.
 
 
3. Subsequently, using a flat-tipped precision screwdriver or similar tool, press the step generated at the part "B" toward the direction of front passenger's seat. Then, pull out the ignition key, and then remove the steering lock cylinder.