[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > ETACS > DIAGNOSIS CODE PROCEDURES > CODE No.U0168 WCM TIMEOUT
Code No.U0168 KOS/WCM CAN timeout
 
 
caution
  • If the diagnosis code No. U0168 is set to the ETACS-ECU, always diagnose the CAN bus line.
  • Before replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
 
 
DIAGNOSTIC FUNCTION
If the signal from KOS&OSS-ECU cannot be received, the ETACS-ECU sets the diagnosis code No. U0168.
 
 
JUDGEMENT CRITERIA
After the following statuses continue to be true for 5 seconds, if the communication with the KOS&OSS-ECU cannot be established for 2,500 ms or more, the ETACS-ECU determines that a problem has occurred.
  • No abnormality is present to the network.
  • Ignition switch is in the "ON" position.
  • No abnormality is present to the power supply fuse (IOD fuse), or the odometer value is at 80.5 km or more.
  • ETACS-ECU system voltage is at 10-16 V.
 
 
PROBABLE CAUSES
  • Malfunction of the KOS&OSS-ECU
  • Malfunction of the ETACS-ECU
  • Malfunction of the CAN bus
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code
Check if diagnosis code is set in the KOS&OSS-ECU.
Is the diagnosis code set?
Troubleshoot the KOS. Refer to GROUP 42B - Diagnosis Code Chart .
Go to Step 3.
 
STEP 3. M.U.T.-IIISE other system diagnosis code
Check if the diagnosis code No. U0168 is set to the SRS-ECU, radio and CD player, combination meter, or A/C-ECU.
Is the diagnosis code set?
Go to Step 4.
Go to Step 5.
 
STEP 4. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the ETACS-ECU.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Check if diagnosis code is set.
Is the diagnosis code set?
Replace the KOS&OSS-ECU.
The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the KOS&OSS-ECU and the ETACS-ECU (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 5. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the ETACS-ECU.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Check if diagnosis code is set.
Is the diagnosis code set?
Replace the ETACS-ECU.
The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the KOS&OSS-ECU and the ETACS-ECU (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).