[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > MITSUBISHI MULTI COMMUNICATION SYSTEM (MMCS) > DIAGNOSIS CODE PROCEDURES > CODE No.U0155 TIME-OUT DURING CAN COMMUNICATION WITH COMBINATION METER
Code No.U0155 Meter CAN timeout
 
 
caution
  • If the diagnosis code No. U0155 is set, be sure to diagnose the CAN bus line.
  • When replacing the CAN box unit, always check that the communication circuit is normal.
 
 
DIAGNOSTIC FUNCTION
If the signal from combination meter cannot be received, the CAN box unit sets the diagnosis code No. U0155.
 
 
 
JUDGEMENT CRITERIA
With the statuses that the ignition switch is at "ON" position, system voltage is 10 - 16 V (data from ETACS-ECU), and there is no malfunction to the power supply fuse (IOD fuse), or odometer value is 80.5 km or more, if the communication with combination meter cannot be established for 2,500 ms or more, the CAN box unit determines that a problem has occurred.
 
 
 
PROBABLE CAUSES
  • Malfunction of CAN bus line
  • Malfunction of combination meter
  • Malfunction of CAN box unit
 
 
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code.
Check again if the diagnosis code is set in the combination meter.
Is the diagnosis code set?
Troubleshoot the combination meter (Refer to ).
Go to Step 3.
 
STEP 3. Check the M.U.T.-IIISE Diagnosis code for other systems.
Check if the diagnosis code No. U0155 is set to A/C-ECU.
Is the diagnosis code set?
Go to Step 4.
Go to Step 5.
 
STEP 4. Diagnosis code recheck.
Check again if the diagnosis code is set in the CAN box unit.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the diagnosis code is set.
Is the diagnosis code set?
Replace the combination meter.
A poor connection, open circuit or other intermittent malfunction in the CAN bus line between the CAN box unit and the combination meter. (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)
 
STEP 5. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the CAN box unit.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if diagnosis code is set.
Is the diagnosis code set?
Replace the CAN box unit.
A poor connection, open circuit or other intermittent malfunction in the CAN bus line between the CAN box unit and the combination meter. (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)