Shock Absorber

REMOVAL & INSTALLATION

ff–1 and 1300G

1. Raise the vehicle body and remove the wheels.

   NOTE: Prior to shock removal, loosen the ride height adjusting cam, and adjust ride height after shock absorber installation is completed.

2. Remove the shock absorber upper double nut, the washer, and the upper rubber bushing.
3. Remove the nut from the damping pin at the bottom of the mount.
4. Remove the shock absorber.

   To install:

5. Install the upper rubber bushing and insert the bolt section into the bracket hole.
6. Temporarily tighten the locknut through the upper side of the rubber and washer.
7. Install the upper mounting section on the mounting pin.
8. Install the washer, spring washer and nut.
9. Tighten the nut until the washer and shoulder of the pin contact.
10. Tighten the upper nut and locknut.