Previous Next

Ignition Coil Pack

REMOVAL & INSTALLATION

  1. Disconnect the negative battery cable.
  2. Tag, then remove each spark plug wire from the coil assembly.
  3. Disconnect the wire harness attached to the coil assembly.

    WARNING
    Failure to identify the correct spark plug wire placement could cause serious coil damage during installation.

  4. Remove the retaining bolts which secure the coil assembly to the intake manifold, and remove the coil from the engine compartment.
  5. Installation is the reverse of removal. Attach the spark plug wires to the coil in the correct order.

Previous Next