Oil Pump

REMOVAL & INSTALLATION

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Drain the cooling system.
3. Drain the engine oil into a separate container.
4. Remove or disconnect the following:
   • Negative battery cable
   • Engine undercover
   • Water pipe and hose between oil cooler and water pump
   • Radiator
   • Crankcase Position (CKP) Sensor
   • Camshaft Position (CMP) Sensor
   • Belt(s) and rear tensioner
   • Crankshaft pulley
   • Water pump
   • Timing belt, and belt guide, if equipped
   • Oil pump mounting bolts and carefully pry the pump from the engine block

   WARNING
   Use extreme care not to damage the engine block or the oil pump during removal of the pump.

   To install:

5. Apply a continuous bead sealant to the mating surfaces of the oil pump.
6. Install or connect the following:
   • New front seal to the oil pump coat the inside of the seal with engine oil
   • New O-ring to the oil pump
   • Oil pump. Torque the bolts to 56 inch lbs. (6.4 Nm).
   • Timing belt, and belt guide, if equipped
   • Water pump
   • Crankshaft pulley
   • Belt(s) and rear tensioner
   • Camshaft Position (CMP) Sensor
   • Crankcase Position (CKP) Sensor
   • Radiator
   • Engine coolant pipe
   • Engine undercover
   • Negative battery cable
7. Refill the cooling system.
8. Refill the engine to the proper level with the recommended oil.