Procedure after ECM Replacement
Precautions: General safety (00)
NOTE:
When ECM and keyless start control module (keyless push start model) or BCM (ignition switch model) are replaced with new ones at the same time, perform “Immobilizer Key Registration” instead of “ECM Registration” using SUZUKI scan tool and security device. Refer to Operator's Manual of SUZUKI scan tool for the immobilizer registration.
After ECM is replaced with new one, perform the following procedure:
1)Program calibration data to ECM. Refer to Operator’s Manual of SUZUKI ECU Programming System.
2)Perform “ECM Registration”.
•Ignition switch model: 
•Keyless push start model:
•Keyless push start model:
3)Perform electric throttle control system calibration.