DTC P2806
Precautions: Precautions for Diagnosing Trouble · Precautions for Disassembly and Reassembly · Precautions for Transmission / Transaxle · General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
P2806: Transmission Range Sensor Alignment N range calibration is not completed. (1 D/C detection logic) |
•TCM
•Select cable |
DTC Confirmation Procedure
1)Set ignition “ON”.
DTC Troubleshooting
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Was “A/T Control System Check” performed?
|
Go to Step 2.
|
Go to A/T Control System Check.
|
| 2 |
Neutral position calibration
1)Calibrate neutral position.
Is calibration completed?
|
End.
|
Go to Step 3.
|
| 3 |
Select cable adjustment
1)Adjust select cable.
2)Calibrate neutral position.
Is calibration completed?
|
End.
|
Go to Step 4.
|
| 4 |
DTC check
1)Clear DTC.
2)Set ignition “OFF”.
3)Perform “DTC Confirmation Procedure”, and check DTC.
Is DTC P2806 still indicated?
|
Substitute a known-good TCM and recheck DTC.
|
End.
|