Clutch Pedal Assembly Removal and Installation
Precautions: General safety (00)
Removal
1)Remove steering column. 
2)Remove push rod from clutch pedal.
3)Disconnect CPP switch connector, and then remove CPP switch from clutch pedal assembly, if necessary.
•CPP No.1 switch:
•CPP No.2 switch:
•CPP No.2 switch:
4)Remove clutch pedal assembly from vehicle body.
Installation
Reverse removal procedure noting the following.
•Tighten each bolt and nut to specified torque.
•Adjust CPP No.1 switch and CPP No.2 switch, if removed.
•If additional lubrication is required, apply grease to specified position.
•Adjust CPP No.1 switch and CPP No.2 switch, if removed.
—CPP No.1 switch:
—CPP No.2 switch:
•Apply grease to push rod tip. —CPP No.2 switch:
•If additional lubrication is required, apply grease to specified position.