Precautions for Service and Diagnosis of Seat Belt
Precautions: Precautions for Restraint · General safety (00)
WARNING:
•If a seat belt is combined with any buckle that is not originally paired with the belt, the latch plate of the belt may not fully engage with the buckle and thus may not lock reliably when the belt is fastened. Always replace the seat belt and buckle as a set. SUZUKI only supplies the buckle and seat belt assembly packaged together as a set.
•A seat belt pretensioner that has been activated can no longer protect the seat belt wearer.
Replace any seat belt whose pretensioner has been activated with a new seat belt and buckle set.
•A seat belt pretensioner that has been activated can no longer protect the seat belt wearer.
Replace any seat belt whose pretensioner has been activated with a new seat belt and buckle set.
Before servicing or replacing seat belt assembly, refer to the following precautions.
•Check if tongue plate and buckle are normal.
•Keep sharp edges and damaging objects away from webbing.
•Never bend or damage buckle and tongue plate.
•Do not bleach or dye webbing. (Use only mild soap and lukewarm water to clean it.)
•When installing a seat belt anchor bolt, first tighten it by hand to prevent cross-threading and then tighten to specified torque.
•Do not attempt any repair on seat belt assembly. If any fault is found, replace the seat belt as an assembly.
•Keep belts dry and clean at all times.
•Any defective part must be replaced with a new one.
•Replace seat belt assembly whose webbing is cut or damaged.
•Do not put anything into trim panel opening which seat belt webbing passes through.
•After an accident, whether the seat belt pretensioner has activated or not, perform checks and repairs described on Repair and Inspection Required after Accident.
•Keep sharp edges and damaging objects away from webbing.
•Never bend or damage buckle and tongue plate.
•Do not bleach or dye webbing. (Use only mild soap and lukewarm water to clean it.)
•When installing a seat belt anchor bolt, first tighten it by hand to prevent cross-threading and then tighten to specified torque.
•Do not attempt any repair on seat belt assembly. If any fault is found, replace the seat belt as an assembly.
•Keep belts dry and clean at all times.
•Any defective part must be replaced with a new one.
•Replace seat belt assembly whose webbing is cut or damaged.
•Do not put anything into trim panel opening which seat belt webbing passes through.
•After an accident, whether the seat belt pretensioner has activated or not, perform checks and repairs described on Repair and Inspection Required after Accident.