SFI SYSTEM > CHECKING MONITOR STATUS |
| OUTLINE |
| DESCRIPTION |
| MID | TID | Scaling | Test Result | Minimum Test Limit | Maximum Test Limit |
| $E1 | $E8 | Multiply by 0.1 [°C] | ECT sensor output when estimated ECT reached to malfunction criteria | Malfunction criteria | Maximum test limit |
| PROCEDURE (USING INTELLIGENT TESTER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch and intelligent tester ON.
Clear DTCs.
Allow the vehicle to drive, in accordance with the applicable drive pattern described in the READINESS MONITOR DRIVE PATTERN section (Click here).
Check the monitor result. Select the intelligent tester menus: DIAGNOSIS/ENHANCED OBDII/MONITOR INFO/MONITOR STATUS. The monitor result appears after the component name.
Check the test value(s). Select the intelligent tester menus: DIAGNOSIS/ENHANCED OBDII/MONITOR INFO/TEST RESULT.
Select the component and press ENTER. If the monitor result has been COMPL or INCMPL, the accuracy test value appears.
Compare the test value with the test limits, MIN and MAX.