SFI SYSTEM > READINESS MONITOR DRIVE PATTERN |
| PURPOSE OF READINESS TESTS |
| TITLE | STEP(s) |
| CATALYST MONITOR | Procedure "A" |
| EVAP MONITOR | Procedure "B", "C" |
| AIR-FUEL RATIO (A/F) AND OXYGEN SENSOR (O2S) MONITOR | Procedure "D" |
| OXYGEN SENSOR HEATER MONITOR | Procedure "E" |
| CATALYST MONITOR (ACTIVE AIR FUEL RATIO CONTROL TYPE) (Procedure "A") |

Preconditions
Drive Pattern
Connect the intelligent tester.
Turn the ignition switch ON.
Turn the intelligent tester ON.
Clear DTC (if set) (Click here).
Start the engine and warm it up [A].
Drive vehicle at between 40 to 70 mph (64 and 113 km/h) for at least 10 minutes [B].
Monitor Status
Check the Readiness Monitor status displayed on the tester.
If the status does not switch to COMPL (complete), extend the driving time.
| EVAP SYSTEM MONITOR (KEY OFF TYPE) |
Preconditions
Monitor Conditions
Turn the ignition switch OFF and wait for 6 hours.
Monitor Status
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester or scan tool ON.
Check the Readiness Monitor status displayed on the tester or scan tool.
| AIR FUEL RATIO (A/F) AND HEATED OXYGEN SENSOR (HO2) MONITOR (ACTIVE AIR FUEL RATIO CONTROL TYPE) |
Preconditions
Drive Pattern for front A/F sensor and rear HO2 sensor
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Clear DTCs (if set) (Click here).
Start the engine, and warm it up until the ECT reaches 75°C (167°F) or higher [A].
Drive the vehicle at 40 mph (64 km/h) or more for at least 10 minutes [B].
Change the transmission to 2nd gear [C].
Accelerate the vehicle to 30 mph (48 km/h) or more by depressing the accelerator pedal for at least 10 seconds [D].
Soon after performing the step above, release the accelerator pedal for at least 4 seconds without depressing the brake pedal, in order to execute fuel-cut control [E].
Allow the vehicle to decelerate until the vehicle speed declines to less than 6 mph (10 km/h) [F].
Repeat steps from [D] through [F] above at least 3 times in one driving cycle [G].
Monitor Status
Check the Readiness Monitor status displayed on the tester.
If the status does not switch to COMPL (complete), make sure that the preconditions have been met, and then perform steps from [A] through [G] in "Drive Pattern" procedures above.

| AIR FUEL RATIO (A/F) AND HEATED OXYGEN (HO2) SENSOR HEATER MONITOR (FRONT A/F AND REAR HO2 SENSOR TYPE) |

Preconditions
Drive Pattern
Monitor Status