DTC P2111 Throttle Actuator Control System - Stuck Open |
DTC P2112 Throttle Actuator Control System - Stuck Closed |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2111 | ECM tries to close throttle valve but throttle position is stuck (1 trip detection logic) |
|
| P2112 | ECM tries to open throttle valve but throttle position is stuck (1 trip detection logic) |
|
| Related DTCs | P2111: Throttle actuator stuck open P2112: Throttle actuator stuck closed |
| Required Sensors/Components (Main) | Throttle actuator motor |
| Required Sensors/Components (Related) | Throttle position sensor |
| Frequency of Operation | Continuous |
| Duration | 0.5 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor will run whenever these DTCs are not present | None |
| System guard* | ON |
| Throttle actuator current | 2 A or more |
| Duty cycle to close throttle | 80 % or more |
| *: System guard is ON when the following conditions are met | - |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executing |
| Throttle position sensor | Fail determined |
| Throttle actuator current-cut operation | Not executing |
| Throttle actuator power supply | 4 V or more |
| Throttle actuator | Fail determined |
| System guard* | ON |
| Throttle actuator current | 2 A or more |
| Duty cycle to open throttle | 80 % or more |
| *: System guard is ON when the following conditions are met | - |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executing |
| Throttle position sensor | Fail determined |
| Throttle actuator current-cut operation | Not executing |
| Throttle actuator power supply | 4 V or more |
| Throttle actuator | Fail determined |
| TP sensor voltage change | No change |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2111 OR P2112) |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P2111 or P2112 | A |
| P2111 or P2112 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK THROTTLE BODY (VISUALLY CHECK THROTTLE VALVE) |
Check for foreign matter between the throttle valve and housing. If necessary, clean the throttle body.
Also, check that the throttle valve moves smoothly.
|
| ||||
| OK | |
| 3.CHECK WHETHER DTC OUTPUT RECURS (DTC P2111 OR P2112) |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch ON and turn the intelligent tester ON.
Clear the DTC (Click here).
Start the engine, and depress and release the accelerator pedal quickly (fully open and close the throttle valve).
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTC.
| Display (DTC Output) | Proceed to |
| No DTC | A |
| P2111 and/or P2112 | B |
|
| ||||
| A | ||
| ||