DTC P0630 VIN not Programmed or Mismatch - ECM / PCM |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0630 |
| ECM |
| Related DTCs | P0630: VIN not programmed |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 0.325 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever this DTC is not present | None |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| VIN code | Not programmed |
| VIN code | Programmed |
| 1.READ CURRENT DTC |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DAC INFO / CURRENT CODES.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0630 | A |
| P0630 and other DTCs | B |
|
| ||||
| A | |
| 2.INPUT VIN WITH INTELLIGENT TESTER |
Input VIN with intelligent tester (Click here).
| NEXT | ||
| ||