Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > MIL Circuit

for Preparation Click here


DESCRIPTION

The Malfunction Indicator Lamp (MIL) is used to indicate the ECM's detection of a vehicle malfunction.
The instrument panel GAUGE fuse provides the circuit with power and the ECM provides the circuit ground that illuminates the MIL.
MIL operations should be checked visually:
The MIL should be illuminated when the ignition switch is turned ON. If the MIL is always ON or OFF, use the intelligent tester and follow the procedures below to determine the cause of the problem.
If the ECM detects trouble, the MIL illuminates. At this time, the ECM records a DTC in the memory.

WIRING DIAGRAM


A130726E01


INSPECTION PROCEDURE

1.CHECK THAT MILL IS ILLUMINATED
  1. Perform troubleshooting in accordance with the chart below.
    Condition
    Proceed to
    MIL remains ON
    A
    MIL does not illuminate
    B



B
Go to step 5
A


2.CHECK WHETHER MIL TURNS OFF
  1. Connect the intelligent tester to the DLC3 with CAN VIM.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Check whether any DTCs have been stored (Click here). Note them down if necessary.

  1. Clear the DTC (Click here).

  1. Check if the MIL turns off.

    OK:
    MIL should turn off.



OK
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
NG


3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)


    G035618E23
  1. Disconnect the E7 ECM connector.

  1. Turn the ignition switch ON.

  1. Check that the MIL is not illuminated.

    OK:
    MIL is not illuminated.



OK
REPLACE ECM
NG


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
  1. Check the harness and connector.



OK
REPAIR OR REPLACE COMBINATION METER
NG

REPAIR OR REPLACE HARNESS AND CONNECTOR 

5.CHECK THAT MIL IS ILLUMINATED
  1. Check that the MIL is illuminated when turning the ignition switch ON.

    OK:
    MIL is illuminated.



OK
SYSTEM OK
NG


6.CHECK THAT ENGINE STARTS
  1. Turn the ignition switch ON.

  1. Start the engine.

    Result:

    Result
    Proceed to
    Engine starts
    A
    Engine does not start*
    B

    HINT:
    *: The intelligent tester cannot communicate with the ECM.



B
GO TO VC OUTPUT CIRCUIT
A


7.INSPECT COMBINATION METER (MIL CIRCUIT)
  1. See the combination meter troubleshooting section (Click here).



NG
REPAIR OR REPLACE COMBINATION METER
OK

CHECK AND REPLACE HARNESS OR CONNECTOR (COMBINATION METER - ECM)