Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR

REAR AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE TONNEAU COVER RETRACTOR SUB-ASSEMBLY


4. REMOVE DECK BOARD ASSEMBLY

HINT:
Click here



5. REMOVE REAR FLOOR MAT SUPPORT PLATE REAR

HINT:
Click here



6. REMOVE DECK FLOOR BOX LH


7. REMOVE REAR DOOR SCUFF PLATE LH


8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


9. REMOVE LAP BELT OUTER ANCHOR COVER REAR NO. 1 SEAT


10. REMOVE DECK TRIM SIDE BOARD UPR LH


11. REMOVE DECK SIDE TRIM COVER LH


12. REMOVE REAR AIRBAG SENSOR LH
  1. Disconnect the connector from the rear airbag sensor LH.



    H042352
  1. Remove the 2 nuts and the rear airbag sensor LH.