Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2797    Communication Malfunction No. 1

for Preparation Click here


DESCRIPTION

This DTC is output when an error occurs in normal communication.

HINT:
Some noise found in the communication line.


DTC No.
DTC Detection Condition
Trouble Area
B2797
Keys are positioned too close to each other, or noise occurred in communication line.
  1. Key
  2. Transponder key amplifier
  3. Wire harness
  4. Transponder key ECU assembly

WIRING DIAGRAM


B145170E01


INSPECTION PROCEDURE

1.CHECK KEY


    B111583E01
  1. Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.

    Result:
    Result
    Proceed to
    Key is near other keys and/or key ring is in contact with key grip.
    A
    Key is not near other keys and / or key ring is not in contact with key grip.
    B



B
Go to step 3
A


2.CHECK DTC OUTPUT
  1. Delete the DTC (Click here).

  1. Insert the key into the ignition key cylinder.

  1. Check that no code is output.

    OK:
    No DTC is output.



OK
END
NG


3.CHECK TRANSPONDER KEY AMPLIFIER


    B111615E12
  1. Using an oscilloscope or the intelligent tester, check the waveform between the terminals of the I17 amplifier and T8 ECU connectors.

  1. Check that no noise is included in the waveform (an example of noise is shown on the left).

    Result:
    Tester Connection
    Specified Condition
    I17-4 (CODE) - T8-11 (CODE)
    No noise is present

    Tool Setting
    10 V/DIV., 10 ms/DIV.
    Condition
    Key inserted into ignition key cylinder.



NG
FIND CAUSE OF NOISE AND REMOVE IT
OK


4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)


    B111591E14
  1. Disconnect the T8 ECU and I17 amplifier connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    T8-10 (CODE) - I17-4 (CODE)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK TRANSPONDER KEY AMPLIFIER
  1. After replacing the transponder key amplifier with a normally functioning transponder key amplifier, check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

END