Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction

for Preparation Click here


WIRING DIAGRAM


E123280E03


INSPECTION PROCEDURE

HINT:
If there is an open or short in the engine coolant temperature sensor circuit, the ECM outputs DTCs. Perform troubleshooting with the "SFI System" (Click herefor 1GR-FE) (Click here for 2UZ-FE).

1.CHECK DTC
  1. Check if DTC is output.

    Result
    Proceed to
    DTC P0115 is not output.
    A
    DTC P0115 is output.
    B



B
GO TO ENGINE CONTROL SYSTEM
A


2.INSPECT COMBINATION METER ASSEMBLY


    E123282E02
  1. Check the input signal waveform.

    1. Remove the combination meter assembly with connectors still connected.

    2. Connect the oscilloscope to the terminal C9-7 (TEMP COMMUNICATION INPUT) and body ground.

    3. Start the engine.

    4. Check the signal waveform according to the condition(s) in the table below.
      Item
      Condition
      Tool setting
      5 V/DIV., 100 ms/DIV.
      Vehicle condition
      Engine idle speed

      HINT:
      As the coolant temperature rises, the period "A" shown in the illustration becomes longer.



NG
Go to step 3
OK

REPLACE COMBINATION METER ASSEMBLY 

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
E113266E05
  1. Disconnect the C9 and E7 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    TEMP COMMUNICATION INPUT (C9-7) - THWO (E7-14)
    Always
    Below 1 Ω
    THWO (E7-14) - Body ground
    Always
    10 kΩ or higher



NG
REPLACE ECM
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR