Home › DRIVE LINE ยท VF4AM TRANSFER › TRANSFER CASE OIL SEAL

TRANSFER CASE OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TRANSFER CASE OIL SEAL


    F043487E02
  1. Coat the lip of a new oil seal with MP grease.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the case upper surface.

    SST
    09316-60011   (09316-00011)



2. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Using SST, install the companion flange sub-assembly using the same procedure as for the companion flange sub-assembly (rear side).

    Torque:
    118 N*m{ 1,200 kgf*cm , 87 ft.*lbf }

    SST
    09330-00021  



3. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER

HINT:
(Click here)



4. INSTALL TRANSFER CASE LOWER PROTECTOR


    F043499
  1. Install the transfer case lower protector with the 4 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



5. ADD TRANSFER OIL
  1. Remove the filler plug and gasket then supply oil.

    NOTICE:
    1. When supplying oil, pour slowly.
    2. Pour the oil in several stages allowing several minutes between each step.

    HINT:
    The oil level should be within 5 mm (0.20 in.) of the bottom of the oil filler plug hole.

  1. After leaving it alone for 5 minutes, check the oil level again.

  1. Tighten the filler plug with a new gasket.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



6. ADD AUTOMATIC TRANSMISSION FLUID

HINT:
(Click here)



7. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
(Click here)



8. WARMING UP


9. DRIVE TEST