Home › DRIVE LINE ยท VF4BM TRANSFER › TRANSFER CASE OIL SEAL

TRANSFER CASE OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TRANSFER CASE OIL SEAL


    F043487E02
  1. Coat the lip of a new oil seal with MP grease.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the case upper surface.

    SST
    09316-60011   (09316-00011)



2. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY


    F044048E02
  1. Install the companion flange sub-assembly (front side) onto the drive sprocket sub-assembly.

  1. Using SST to hold the companion flange, install a new companion flange lock nut.

    SST
    09330-00021  

    Torque:
    118 N*m{ 1,200 kgf*cm , 87 ft.*lbf }

  1. Using a chisel and hammer, stake the companion flange lock nut.



3. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER

HINT:
(Click here)



4. INSTALL TRANSFER CASE LOWER PROTECTOR


    F043499
  1. Install the transfer case lower protector with the 4 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



5. ADD TRANSFER OIL


6. ADD AUTOMATIC TRANSMISSION FLUID


7. INSPECT AUTOMATIC TRANSMISSION FLUID


8. WARMING UP


9. DRIVE TEST