EXTENSION HOUSING OIL SEAL > INSTALLATION |
| 1. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL |
![]() |
Coat the lip of a new oil seal with MP grease.
Using SST and a hammer, tap in the oil seal until its surface is flush with the housing upper surface.
| 2. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY |
Using SST, install the companion flange sub-assembly using the same procedure as for the companion flange sub-assembly (rear side).
| 3. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER |
| 4. INSTALL TRANSFER CASE LOWER PROTECTOR |
![]() |
Install the transfer case lower protector with the 4 bolts.
| 5. ADD TRANSFER OIL |
Remove the filler plug and gasket then supply oil.
After leaving it alone for 5 minutes, check the oil level again.
Tighten the filler plug with a new gasket.
| 6. ADD AUTOMATIC TRANSMISSION FLUID |
| 7. INSPECT AUTOMATIC TRANSMISSION FLUID |
| 8. WARMING UP |
| 9. DRIVE TEST |