Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > INSTALLATION

for Preparation Click here



1. INSTALL REAR AXLE HUB BOLT


    G020976
  1. Pass a new hub bolt through the axle hub.

  1. Pass a washer plate, as shown in the illustration, through the hub bolt, and install the hub bolt as tightening the hub nut.



2. INSTALL PARKING BRAKE SHOE
  1. Install the shoe lever and the shim to the rear shoe with a new C-washer.



    R000343
  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    Less than 0.25 mm (0.0098 in.)

    If the clearance is not within the specification, replace the shim with one of the correct size.
    Shim Thickness
    Shim Thickness
    0.3 mm (0.012 in.)
    0.6 mm (0.024 in. )
    0.4 mm (0.016 in.)
    0.9 mm (0.035 in.)
    0.5 mm (0.020 in.)
    -



    F041705
  1. Apply the high temperature grease to the adjusting bolt and piece.

  1. Install the shoe adjusting screw set and the tension spring to the front and rear shoe.

  1. Install the 2 pins, 4 cups and 2 shoe hold-down springs.

  1. Connect the parking brake cable to the shoe lever.

  1. Install the front and rear parking brake shoe.



3. INSTALL PARKING BRAKE SHOE STRUT


4. INSTALL PARKING BRAKE SHOE STRUT COMPRESSION SPRING


5. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING
  1. Using a needle nose pliers, install the 2 return tension springs.

    HINT:
    Install front side spring first, rear side spring next.



6. INSTALL REAR DISC


7. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY


    F043124
  1. Apply the lithium soap base glycol grease to the sliding part of 2 cylinder slide pins.

  1. Install the disc brake cylinder assembly rear with 2 cylinder slide pins.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



8. INSTALL REAR SPEED SENSOR


    F043113
  1. Install the rear speed sensor with the nut to the steering knuckle.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

    NOTICE:
    Make sure the sensor tip is clean.



    F043111
  1. Connect the speed sensor connector.



9. ADJUST RESERVOIR WITH BRAKE FLUID


10. BLEED BRAKE LINE


11. INSPECT BRAKE FLUID LEVEL IN RESERVOIR


12. INSPECT BRAKE FLUID LEAKAGE


13. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,142 kgf*cm , 83 ft.*lbf }



14. INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL

HINT:
(Click here)



15. INSPECT ABS SPEED SENSOR SIGNAL

HINT:
(Click here)