DTC 01-DD Master Reset |
DTC 01-E1 Voice Processing Device ON Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-DD *1 | The device that should be the master has been disconnected after the engine starts. |
|
| 01-E1 *2 | The AMP device records that the AMP output does not function even while the source device is operating. |
| 1.CHECK RADIO AND NAVIGATION ASSEMBLY POWER SOURCE CIRCUIT |
| NEXT | |
| 2.INSPECT RADIO AND NAVIGATION ASSEMBLY |
![]() |
Disconnect the radio and navigation assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ATX+ (R12-5) - ATX- (R12-15) | Always | 60 to 80 Ω |
| TXM+ (R11-9) - TXM- (R11-10) | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 3.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component which has stored this code.
| Display | Component |
| Rr-TV | Television display assembly |
| DSP-AMP | Stereo component amplifier |
| NEXT | |
| 4.CHECK HARNESS AND CONNECTOR |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio and navigation assembly and the component which has stored this code.
Disconnect all connectors between the radio and navigation assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio and navigation assembly and the component which has stored this code.

|
| ||||
| OK | |
| 5.REPLACE RADIO AND NAVIGATION ASSEMBLY |
Replace the radio and navigation assembly with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||