DTC 01-DF Master Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-DF *1 | The device with a display fails and the master is switched to the audio device. Also when a communication error between sub-master (audio) and master occurs, this code is stored. |
|
| 1.CHECK RADIO RECEIVER POWER SOURCE CIRCUIT |
| NEXT | |
| 2.INSPECT RADIO RECEIVER |
![]() |
Disconnect the radio receiver connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ATX+ (R1-5) - ATX- (R1-15) (*1) | Always | 60 to 80 Ω |
| TXM+ (R4-9) - TXM- (R4-10) | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 3.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE |
Enter the diagnostic mode.

Press the preset switch "3" to change to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical address |
| Stereo component amplifier | 440 |
| Television display assembly | 1B0 |
| NEXT | |
| 4.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver and the component which has stored this code.
Disconnect all connectors between the radio receiver and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver and the component which has stored this code.

|
| ||||
| OK | |
| 5.REPLACE RADIO RECEIVER |
Replace the radio receiver with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||