DTC P050A Cold Start Idle Air Control System Performance |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P050A | Accumulated intake air amount during 10 seconds of idling after cold start, less than threshold (2 trip detection logic) |
|

| Related DTCs | P050A: Idle speed control problem at cold |
| Required Sensors/Components (Main) | Mass air flow meter |
| Required Sensors/Components (Related) | Engine Coolant Temperature (ECT) sensor, Throttle position sensor, Vehicle speed sensor |
| Frequency of Operation | Once per driving cycle |
| Duration | 10 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor will run whenever these DTCs are not present | None |
| Battery voltage | 8 V or more |
| Time after engine start | 3 seconds or more |
| Starter | OFF |
| ECT at engine start | -10°C (14°F) or more |
| ECT | -10°C to 50°C (14°F to 122°F) |
| Engine idling time | 3 seconds or more |
| Fuel-cut | OFF |
| Vehicle speed | Less than 1.86 mph (3 km/h) |
| Time after shift position changed | 1 second or more |
| Accumulated air flow amount | Varies with ECT (Example: Less than 102 g) |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P050A) |
Connect an intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch to ON.
Turn the tester ON.
Select the following the menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read the DTCs.
| Display (DTC Output) | Proceed To |
| P050A | A |
| P050A and other DTCs | B |
|
| ||||
| A | |
| 2.READ VALUE OF INTELLIGENT TESTER (FUEL TRIM) |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch to ON.
Turn the tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / PRIMARY / SHORT FT #1 and LONG FT #1.
Read the values displayed on the tester.
Add together the SHORT FT #1 and LONG FT #1 values to obtain the total FUEL TRIM.
|
| ||||
| NG | |
| 3.CHECK VENTILATION HOSE CONNECTIONS |
|
| ||||
| OK | |
| 4.CHECK AIR INDUCTION SYSTEM |
Check the air induction system for vacuum leakage.
|
| ||||
|
| ||||
| 5.REPAIR OR REPLACE VENTILATION HOSE |
|
| ||||
| 6.REPLACE MASS AIR FLOW METER |
|
| ||||
| 7.REPAIR OR REPLACE AIR INDUCTION SYSTEM |
|
| ||||
| 8.CHECK THROTTLE VALVE |
Check for deposits around the throttle valve.
|
| ||||
|
| ||||
| 9.REPLACE ECM |
|
| ||||
| 10.REPAIR OR REPLACE THROTTLE BODY ASSEMBLY |
| NEXT | |
| 11.CHECK WHETHER DTC OUTPUT RECURS (DTC P050A) |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch to ON.
Turn the tester ON.
Clear DTCs (Click here).
Switch the ECM from normal mode to check mode using the tester (Click here).
Start the engine to idle for a minute.
Read DTCs.
| NEXT | ||
| ||