VEHICLE STABILITY CONTROL SYSTEM > CALIBRATION |
| DESCRIPTION |
| Replacement / Adjustment Parts | Necessary Operations |
| Master cylinder solenoid (Skid control ECU) | Yaw rate and acceleration sensor zero point calibration. |
| Yaw rate and acceleration sensor | 1. Clearing zero point calibration data. 2. Yaw rate and acceleration sensor zero point calibration. |
| Front wheel alignment | 1. Clearing zero point calibration data. 2. Yaw rate and acceleration sensor zero point calibration. |
| Rear air suspension | 1. Clearing zero point calibration data 2. Yaw rate and acceleration sensor zero point calibration |
| CLEAR ZERO POINT CALIBRATION (SST CHECK WIRE) |
Turn the ignition switch to the ON position.
![]() |
Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
![]() |
Check that the warning light indicates the normal system code.
Remove the SST from the terminals of the DLC3.
Using a check wire, perform zero point calibration of the yaw rate and acceleration sensor.
| PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR (SST CHECK WIRE) |
Procedures for test mode:
Turn the ignition switch off.
![]() |
Using SST, connect terminals TS and CG of the DLC3.
Check that the steering wheel is in the straight- ahead position and more the shift lever to the P position.
Turn the ignition switch to the ON position.
Keep the vehicle in a stationary condition on a level surface for 2 seconds or more.
![]() |
Check that the VSC TRAC warning light is blinking in test mode.
| CLEAR ZERO POINT CALIBRATION (INTELLIGENT TESTER) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Operate the intelligent tester to erase the codes.

Using the intelligent tester, perform zero point calibration of the yaw rate and acceleration sensor.
| PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR (INTELLIGENT TESTER) |
Procedures for test mode.
Check that the steering wheel is in the straight-ahead position and move the shift lever to the P position.
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Set the intelligent tester in test mode ("TEST MODE").
Keep the vehicle in a stationary condition on a level surface for 2 seconds or more.
![]() |
Check that the VSC TRAC warning light is blinking in test mode.